Veo Observer - Manual (Page 6)

Page 6 of 65
Network Activity LED
The green LED indicates if
there is a connection to your
network and router. If there is
network activity, the green
LED will blink.
Motion Sensor Jack
Connect an external motion
sensor* to trigger email alerts
with images attached. See the
motion detection section for
more information. (Optional)
External Microphone Connection Port
Connect a standard 1/8” (3.5 mm) computer
microphone* into this port to monitor/record
audio further away. (Optional)
RJ-45 Ethernet Port
Used to connect the Observer
to your LAN using the included
Ethernet cable.
1.3 Hardware Description and Features
Rear Connections
* (External microphone and motion sensor sold separately)
IP Address Display
Power Button
Turn the camera on or off. When the power button is
held down while the camera is on for 6 seconds the
camera settings will reset to the factory defaults.
The power button light will blink when video is being
streamed.
Lens
VGA CCD sensor with fixed focus lens.
Microphone
Monitor or record sound using the built-in microphone.
IP Address LCD
The LCD will indicate the last three digits of your IP Address. For
example, if the IP Address “192.168.0.123” is assigned to the
Veo Observer Camera, the LCD will display “123.” Refer to
Section 2.2 Getting an IP address for more information.
Observer - Connections
External Power Connector
Connect the included power
supply.
Warning: Use only the
included power supply
or you may damage
your camera.