VXI TECHNOLOGY SVM2608 - Manual (Page 18)

VXI Technology, Inc.
18 SVM2608 Introduction
P HYSICAL D ESCRIPTION
The SVM2608 has a protective coating applied to it to ensure that the effects of environmental
hazards are minimized. This coating endows the modules with resistance to salt sprays, moisture,
dust, sand, and explosive environments, as the polymer coating provides a hermetic seal. The
module is designed to withstand the stress and rigors of shock and vibration, allowing the module
to be deployed in a variety of applications without concern for damage due to the surrounding
physical environment. The following table details the environmental specifications of this
module.
T
ABLE
1-1: SVM2608 E
NVIRONMENTAL
S
PECIFICATIONS
SVM E NVIRONMENTAL S PECIFICATIONS
C LASSIFICATION MIL-T-28800E Type III, Class 5, Style E or F
T EMPERATURE
O PERATIONAL
N ON -O PERATIONAL
Meets functional shock requirements of MIL-T-28800E, Type III, Class 5
-20°C to 65°C
-40°C to 71°C
H UMIDITY 5% to 95% (non-condensing)
A LTITUDE
O PERATIONAL
S USTAINED S TORAGE
Sea level to 15,000 ft (4,570 m)
Sea level to 40,000 ft (12,190 m)
R ANDOM V IBRATION
O PERATIONAL
N ON -O PERATIONAL
Three axis, 30 minutes total, 10 minutes per axis
0.27 g
rms
total from 5.0 Hz to 55.0 Hz
2.28 g
rms
total from 5.0 Hz to 55.0 Hz
F UNCTIONAL S HOCK Half sine, 30 g, 11 ms duration
S ALT A TMOSPHERE > 48 hrs operation
S AND AND D UST > 6 hrs operation in a dust environment of 0.3 g/ft 3 blowing at 1750 ft/min
The SVM2608 has two indicator LEDs located on its front panel. The A/E (Access/Error) LED
flashes green when read/write commands are being sent to the module. Should the SVM2608
receive an error, the LED glows red. This LED can be overridden by the user by setting the Sysfail
bit in the Reset, Sys Fail Control, Interrupt Levels Register. The P/F (Power/Fail) LED glows
green indicates the status of a processor driven self-test. If the self-test is successful, the P/F LED
glows green, if the test fails, however, the LED will glow red. Both the A/E and P/F LEDs can be
programmed to glow red when a fail condition occurs.
F IGURE 1-3: SVM2608 F RONT P ANEL
J100
P/F A/E
HS TRIG
CH 4 -
CH 4 +
CH 5 -
CH 5 +