Verilux ClearWave CWST2RB - Manual (Page 9)

9
Operating Instructions
Proper Use Operations
Note:
• For best results, remove all make-up and wash your
face with a neutral pH cleanser.
• During use, hold the device in a single location until
the cycle is complete.
Step 1: To ACTIVATE, push the Power Button until the
device beeps once, indicating that the care
cycle is ready to begin.
Step 2: Apply protective eyewear (goggles).
Step 3: To START, place the device against the
desired area of your skin to receive care. The
LED lights will turn on and the cycle will begin
once the device is in contact with your skin.
Step 4: Hold device fi rmly in place until the device
beeps twice signaling that the care cycle
is complete. Do not move the position of
the device on your skin. Device will beep if
removed from skin — see page 10.
Step 5: Replace the ClearWave ® Soothing Skin
System to the Charging Stand to fully charge
for the next treatment.
Note: To manually turn OFF the ClearWave ®
Soothing Skin System prior to the end of a cycle,
push and hold the Power Button for approximately 3
seconds until the device beeps twice.
Step 1
Step 2
Step 3
Step 4
Step 5
The daily care regimen is the same for both interchangeable heads. When
using the ClearWave
® Soothing Skin System, care for each desired area
of the skin for the 3 minute cycle. You may care for a particular area up to a
maximum of 15 minutes (5 cycles) in a 24 hour period. For optimal results,
allow 24 hours before your next care cycle.
Daily Care for Your Skin