Volvo V70 - Manual (Page 130)

2007 Volvo V70
Temporarily turning off the inclination and movement alarm sensor(s) - accessory
This button will only be found in vehicles equipped with the accessory inclination and/ or movement
sensors.
FCC ID: MAYDA5823
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Canadian IC: 4405A-DA5823
Movement sensor DA5823 by Dynex
Operation is subject to the following conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
In certain situations it may be desirable to turn off the accessory inclination and movement alarm
sensors if, for example, you drive your vehicle onto a ferry where the rocking of the boat could trigger
the alarm or if a pet is left in the vehicle with the doors locked.
To temporarily turn off the inclination and movement alarm sensors from the alarm system:
From the time the ignition key is turned from the Drive position (position II) until you lock the vehicle,
you can press the button in the center console. The LED in the switch will light up and a message will be
displayed in the text window to indicate that the sensors are disconnected.
The vehicle can then be locked in the usual way to set the alarm.
NOTE:
●
This function will not turn off the vehicle's standard alarm.
●
The optional sensors are automatically reconnected to the alarm system the next time the vehicle is
unlocked and then locked again.
file:///K|/ownersdocs/2007/2007_V70/07v70_05.htm (11 of 12)12/30/2006 5:49:35 PM