Volvo V70 User Manual
Page 60
2007 Volvo V70
1. Turn signals, lane change position
2. Turn signals, position for normal turns
3. High beam flash
4. Toggle between high and low beams, Home Safe lighting
Turn signals
When turning
Move the lever as far up or down as possible (to position 2) to start the turn signals. The turn signals will
be cancelled automatically by the movement of the steering wheel, or the lever can be returned to its
initial position by hand.
When changing lanes
The driver can automatically flash the turn signals 3 times by:
●
Moving the turn signal lever up or down to position 1 and releasing it.
●
Moving the lever up or down to position 2 and immediately back to its original position.
NOTE:
●
This automatic flashing sequence can be interrupted by immediately moving the lever in the opposite
direction.
●
If the turn signal indicator flashes faster than normal, check for a burned-out turn signal bulb.
High/low beam headlights
Continuous high beams
- Turn the ignition key to position II.
- With the light switch (1) in position
) pull the turn signal lever toward the steering
wheel (position 4) to toggle between high and low beams (this also applies on models equipped with the
optional Active Bi-Xenon headlights).
High beam flash
- Turn the ignition key to position II.
- Pull the turn signal lever to position 3. The high beams will remain on until the lever is released.
Home safe lighting
When you leave your vehicle at night, you can make use of the home safe lighting function to illuminate
the area in front of the vehicle.
- Remove the key from the ignition switch.
- Pull the direction indicator lever as far as possible towards the steering wheel (to position 4) and
release it.
- Exit the vehicle and lock the doors.
file:///K|/ownersdocs/2007/2007_V70/07v70_02.htm (16 of 35)12/30/2006 5:49:29 PM