Pg. 244 audio, Homelink® universal transceiver (option) – Volvo V70 User Manual
Page 272
2007 Volvo V70
- Begin by erasing all 3 factory default channels. Hold down the two outside buttons (buttons 1 and 3 in
the illustration) on the HomeLink® Universal Transceiver for about 20 seconds, until HomeLink®'s
indicator light begins to flash. Then release the buttons.
- Hold your hand-held transmitter (garage door opener, for example) 2 to 5 in. (5 to 12 cm) away from
the HomeLink® surface, keeping the indicator light in view. For placement questions, contact
HomeLink® toll-free 1-800-355-3515 (Internet:
).
- Using two hands, push and hold both your hand-held transmitter's button and the transceiver button
you wish to program.
The indicator light will flash first slowly, then rapidly. Rapid flashing tells you the HomeLink® button
has been successfully programmed. Release both buttons.
- If you are programming a rolling code-equipped device (e.g., garage door opener or entry door lock),
refer to "Programming rolling codes" on the next page to complete the programming process.
Repeat the third and fourth steps to program the other two transceiver buttons.
If, after several attempts, you are unable to successfully train the HomeLink® Universal Transceiver to
).
pg. 244 Audio
HomeLink® Universal Transceiver (option)
WARNING!
If you use HomeLink® to open a garage door or gate, be sure no one is near the gate or door while it
is in motion.
Do not use the HomeLink® Universal Transceiver with any garage door opener that lacks safety
"stop" and "reverse" features as required by federal safety standards. (This includes any garage door
opener model manufactured before April 1, 1982) A garage door opener that cannot "detect" an
object, signalling the door to "stop" and "reverse" does not meet current federal safety standards.
Using a garage door opener without these features increases the risk of serious injury or death. For
NOTE: Canadian residents: During programming, your hand-held transmitter may automatically stop
transmitting. To successfully train HomeLink®, continue to hold the HomeLink® button. At the same
time, repeatedly press and hold your handheld transmitter's button at two-second intervals until
HomeLink® has learned your transmitter's code. The HomeLink® indicator light will flash first slowly,
and then rapidly to indicate that the button has been successfully programmed.
file:///K|/ownersdocs/2007/2007_V70/07v70_11.htm (20 of 22)12/30/2006 5:49:50 PM