Visioneer One Touch 9420 - Manual (Page 69)

62 V ISIONEER O NE T OUCH 9420 USB S CANNER U SER ’ S G UIDE
P
OSITIONING
35
MM
S
LIDES IN THE
M
ASK
1. Place the mask on the glass so the arrow on the mask labeled Use
this mask for scanning 35mm slides is aligned with the arrow in
the upper left corner of the scanner.
Make sure the text on the mask faces up so it fits properly on the
glass, aligned at the corner.
2. Follow the printed directions on the mask and place the 35mm
slides horizontally into the slide holder.
Notice that the mask has a narrow slot next to the slide holder. That
slot is for calibration to assure that you get the best possible scan
results. Do not place items in the calibration slot.
3. Close the lid. You’re now ready to start scanning the slides.
4. See “Scanning 35mm Slides or Negatives from the TWAIN
Interface” on page 64 to start the scanning.
Calibration slot.