Visioneer One Touch 9420 - Manual (Page 76)

S CANNING 35 MM S LIDES AND N EGATIVES 69
■ Remove an image from scanning—You may want to only scan
one negative in a filmstrip. In that case, you remove selection
boxes around the other images. To remove a selection box, select
it by either clicking in it or clicking its tab on the Scan Info box,
then click the Remove button on the Scan Info box.
8. You can also adjust the image quality and select new TWAIN
settings. See “Adjusting the Image on the Advanced Interface” on
page 51 for details about adjusting settings.
9. Click Scan when you are satisfied with the image.
10. When you’re finished scanning the slides or negatives, click Done
to close the Advanced Interface.
11. The scanned image appears in the scanning application, where you
can then modify the image.
To remove a selection box, select it by
clicking on it or clicking its tab, then
click the Remove button.
Tip: For 35mm slides or negatives, set the resolution to 1200 dpi or
better. Visioneer recommends using a resolution of 2400 dpi. Refer to
“Adjusting the Resolution” on page 53 for steps to set the resolution.