MAXWELL MW-3003 VT - Manual (Page 5)

5
ENGLISH
• To avoid appearance of glossy spots
on the synthetic and silk fabrics, iron
them back-side.
SETTING THE IRONING
TEMPERATURE
• Place the iron on the base (8).
• Insert the power plug into the outlet.
•
Set the temperature regulator (11)
to the required ironing temperature:
“•”, “••”, “•••” or “max” (depend-
ing on the type of fabric), the (9) indi-
cator will light up.
• When the sole temperature (13)
reaches the desired temperature val-
ue, the (9) indicator will go out, you
can start ironing.
Note: While steam ironing set the
temperature «•••» or «МАХ».
WATER SPRAYER
• You can dampen the fabric by press-
ing the spray button (4) several
times.
• Make sure that there is enough water
in the water tank (10).
IRONING
• Place the iron on the base (8).
• Insert the power plug into the outlet.
•
Set the temperature regulator (11)
to the required ironing temperature:
“•”, “••”, “•••” or “max” (depend-
ing on the type of fabric), the (9) indi-
cator will light up.
• When the sole temperature (13)
reaches the desired temperature val-
ue, the (9) indicator will go out, you
can start ironing.
• After you finish ironing set the (11)
regulator to the “min” position.
• Pull the plug out of the socket and let
the iron cool down completely.
STEAM IRONING
For steam ironing set the temperature
regulator to «•••» or «МАХ».
• Place the iron on the base (8).
• Insert the power plug into the outlet.
• Make sure that there is enough water
in the water tank (10).
• Set the temperature regulator (13)
to the required ironing temperature:
“•••” or “max”, the (9) indicator will
light up.
• When the sole temperature (13)
reaches the desired temperature val-
ue, the (9) indicator will go out, you
can start ironing.
• Turn the steam supply regulator (3) to
set the intensity of steaming, steam
will start outgoing from the openings
of the sole (13).
• After you finish ironing set the (11)
regulator to the “min” position and
the steam supply regulator (3) to the
low position.
• Pull the plug out of the socket and let
the iron cool down completely.
ATTENTION!
If during the operation steam is not
constantly supplied, check whether the
temperature regulator (11) is set prop-
erly.
ADDITIONAL STEAM RELEASE
Additional steam release function is
useful when ironing folds and can only
be used at high ironing temperatures
(when the iron temperature regulator
(11) is set to “•••” or “max”).
• When the additional steam release
button (5) is pressed, steam will be
vigorously released from the open-
ings in the iron sole.
Note: In order to avoid leakage of
water from steam openings, press
MW-3003.indd 5 MW-3003.indd 5 26.05.2009 10:21:45 26.05.2009 10:21:45