Vantec UGT-ST310R - Manual (Page 11)

UGT-ST310R Page 11
6. Select chunk size from 8k, 16k, 32k, 64 or 128k, then press
Enter.
7. Select the first drive, press Enter.
8. Select the second drive, press Enter.
9. Select the third drive, press Enter.
10. Select the fourth drive, press Enter.
11. Select Create without data copy then press Enter.
12. Input the RAID size, press Enter.
13. When asked Are You Sure(Y/N)?, press Y to accept.
14. Press Ctrl+E to exit the BIOS.
15. When asked Are you sure to exit(Y/N)?, press Y to exit
and reboot.
16. Continue with FDISK and FORMAT steps as if you were
installing a conventional hard drive.
RAID 5 (Parity)
This RAID array to be used on New/Blank hard drives. Striping
will destroy existing data on the hard drive. Auto Configuration
is recommended. For applications that require custom chunk
size, Manual Configuration is offered.
Auto configuration (recommended)
The default chunk size is 64k when selecting Auto
configuration.
1. As the BIOS boots press Ctrl+S or F4 when prompted to
enter the RAID BIOS
2. At the next screen select Create RAID Set, then press