Vantec UGT-ST310R - Manual (Page 17)

UGT-ST310R Page 17
For An Existing Installation
1.
Setup the RAID Array prior to driver installation and boot up
to Windows.
2. At the Found New Hardware Wizard, select No, not this
time, then click Next.
3. Insert the driver CD, select Install the software
automatically (Recommended), and click Next.
4. Click Finish.
5. Restart Windows to complete the driver installation.
For Windows® XP-x64/Server 2003-x64
For A New Installation
A new installation requires a floppy disk for the driver
installation. To make this floppy disk, copy the contents
of the “
UGT-ST310R\XP_2003_Vista\64bit ” folder, found
on the driver CD, onto a blank floppy disk then follow the
directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Microsoft’s Windows installation procedure.
3. At the Windows Setup screen, press F6 to install the RAID
driver.
4. When prompted, press S to specify the location of the
driver.
5. Insert the floppy disk, then press Enter.
6. Select
Silicon Image SiI 3114 SoftRAID 5 Controller (64-
bit Extended), then press Enter.
7. Press Enter to finish driver installation, then follow the on-
screen instructions to complete the Windows installation.
For An Existing Installation