Vantec UGT-ST310R - Manual (Page 6)

UGT-ST310R Page 6
drive.
4. Attach the other end of the Serial ATA cable to the Serial
ATA controller on the 6-Port SATA II 150 PCI Host Card
w/RAID.
5. Follow the same instructions to connect up to four hard
drives. Device connection is now complete.
6. Replace the computer cover and reconnect the power cord.
RAID Arrays
RAID Arrays are setup in the 6-Port SATA II 150 PCI Host Card
w/RAID’s BIOS.
RAID 0 (Striping)
This RAID array to be used on New/Blank hard drives. Striping
will destroy existing data on the hard drive. Auto Configuration
is recommended. For applications that require custom chunk
size, Manual Configuration is offered.
Auto configuration (recommended)
The default chunk size is 64k when selecting Auto
configuration.
1. As the BIOS boots press Ctrl+S or F4 when prompted to
enter the RAID BIOS.
2. At the next screen select Create RAID Set, then press
Enter.