Vanson V-6000 - Manual (Page 50)

50
Metering
If you cannot obtain suitable exposure conditions, you can change the metering method to take brighter
pictures.
MULTI( ) : Exposure will be calculated based on an
average of the available light in the image
area. However, the calculation will be
biased towards the centre of the image
area. This is suitable for general use.
SPOT( ) : Only the rectangular area in the center
of the LCD monitor will be metered for
light. This is suitable when the subject
in the center is exposed correctly, regardless of the back lighting.
The default metering mode is Multi pattern metering.
If the subject is not the centre of the focus area, do not use the spot metering as this may
result in an exposure error. In this circumstance, rather use exposure compensation.
INFORMATION
Continuous shot
Select the number of pictures in continuous shooting.
- [SINGLE] : Take one picture only
- [2, 4, 8 SHOTS] : Take the set number of pictures with one
push of the shutter. Continuous shooting
mode is cleared after one shooting.
2048
SHOOTING
SINGLE
2 SHOTS
4 SHOTS
8 SHOTS
NOR
[ PROGRAM mode ]
2048
METERING
MULTI
SPOT
2816 NOR