Valor Auto Companion Inc. Valor Legend Ultra 837 AN - Manual (Page 3)

Safety Upgrade Instructions
Page 3
Figure 7. Fitting the locating
bracket.
Figure 6. Removal of Bushing.
Figure 5. Removal of Screw from
locating bracket.
2. Removal of bushing from ignition bar
For models fitted with a locating bracket (See figure 5)
1. Remove the self-tapping screw from the
ignition bar locating bracket (See figure 5).
2. Place a suitable flat instrument on the
underside of the bushing and lift the bushing
clear of the mounting bracket (see figure 6).
3. Pull the ignition bar forward and clear of the
mounting bracket.
4. Remove bushing from ignition bar by sliding
up around bend and off bar. If bushing is too
tight to slide off, cut off bushing with a utility
knife.
5. With the bushing removed, push the ignition
bar back into the mounting bracket.
6. Replace the locating bracket and secure using
the self-tapping screw removed previously.
For models NOT fitted with a locating bracket
(See figure 5)
7. Place a suitable flat instrument on the
underside of the bushing and lift the bushing
clear of the mounting bracket (see figure 6).
8. Pull the ignition bar forward and clear of the
mounting bracket.
9. Remove bushing from ignition bar by sliding
up around bend and off bar. If bushing is too
tight to slide off, cut off bushing with a
utility knife.
10. With the bushing removed, push the ignition
bar back into the mounting bracket.
11. Position the locating bracket with its sides in
line with those of the mounting bracket (See
figure 7). Mark the position of the hole.
12. Remove the bracket and drill a 3.5mm (1/8
in) hole
13.
Reposition the location bracket
and secure using a self-tapping screw.