Vision Fitness T9800 Series - Manual (Page 5)

5
1
STEP
1
STEP
• Remove motor cover screws and
take off the motor cover.
• Insert the right console mast to the
right console mast bracket. First, fasten
the inside of the console mast to the
console mast bracket by securing four
bolts (M8x15L socket head) and four
washers (8.2x19x2T). Fully tighten the
bolts. Second, fasten the two bolts
(M10x20L button head) and two
washers (10.2x19x2T) on the front of
the console mast and fully tighten.
• Repeat on the left side
ORANGE BAG
2
STEP
• Tie the ribbon data cable to the
cable wire tie on the top of the right
console mast. Feed the ribbon cable
down the console mast and through the
hole at the lower part of the console
mast. Push any remaining cable into
the console mast.
• Mount the console onto the left and
right console masts using four bolts
(M8x15L socket head) and four washers
(8.2x19x2T). Do not fully tighten.
• Take the wire tie off the ribbon
cable. Plug the large 20-pin ribbon
connector into the 20-pin connector
on the lower control board. Attach the
two grounding wire connectors to the
two grounding wires located in the
motor pan near the front of the frame.
BLUE BAG
2
STEP