Vidikron 85 - Manual (Page 29)

Installation
Vidikron Vision 85 Owner’s Operating Manual 17
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the Vision 85 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video installation
specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 18
2
If installing a Vision 85/CineWide or Vision 85/CineWide
with AutoScope: Install fixed CineWide base plate or
AutoScope lens motor (optional) 23
3 Mount the projector 27
4 Connect the VHD Controller to the projector 28
5 Connect signal sources to the VHD Controller 29
6 Connect external controller to RS-232 port (optional) 33
7
Connect other home theater components to 12-volt trigger
outputs (optional) 34
8
Connect the projector, VHD Controller and AutoScope lens
motor (if present) to power and turn on the system 36
9
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation 37
10
Primary lens adjustments: projected image size (zoom),
position (shift) and focus 20, 37
11 Install CineWide anamorphic lens (optional) 38
12
CineWide lens adjustments: position, pitch (angle), geometry
and focus 39
13
Projector calibration – Analog 1080i and lower-resolution
signals:
Adjust the following for Component SD input; save settings
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
49 through 62
14
Repeat Step 13 for S-Video 1, S-Video 2, Composite Video,
HD1 and HD2 inputs
Note