Vidikron Vision v120 - Manual (Page 54)

Installation
42 Vidikron Vision Model 120 Owner’s Operating Manual
PRE
L
IMINAR
Y
3.11
Installing and Adjusting
the CineWide Anamorphic
Lens If you are installing a CineWide-equipped projector, proceed as follows to install and adjust
the anamorphic lens.
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate (CineWide
with AutoScope) or Base
Plate (fixed CineWide)
The Vision 120 Anamorphic lens mount kit consists of everything shown in Figure 3-19. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Vidikron dealer or
Vidikron Customer Service at (888) 4VIDIKRON.
Figure 3-19. Vision 120 Anamorphic Lens Mounting Assembly - Exploded View
1. Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the Anamorphic
Lens Holder (item #5).
2. Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate or fixed
CineWide Base Plate (item #7). Position the bracket so that the long slot at the bottom of
the lens holder is perpendicular to the corresponding slots on the plate.
It is extremely important that the primary lens is properly adjusted
before you install the anamorphic lens. Ensure that the image from
the primary lens is perfectly centered on the screen.
Note
➤
2
3
4
6
7
8
5
1
9
Pitch Adjustment Yoke for Lens
Height/Y Adjustment
T-Screw and Washer
(2x)
T-Screw and
Washer (2x)
Pitch Adjustment
Anamorphic Lens
Holder
1/4-20 Hex Bolt (2x)
and Washer (2x)
AutoScope Carriage Plate or
Fixed CineWide Base Plate
Yaw/X Adjustment
Lever (2x)
Lens Adapter Ring and
Mounting Screws (3x)
Pitch Adjustment
T-Nut (2x)
10 Anamorphic Lens
Set Screw