Vivotek FD7141(V) - Manual (Page 10)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
10 - User's Manual
Ceiling mount without the bottom base (Embedded)
1� Attach the supplied Ceiling Hole Template Sticker to the wall�
2� Dig a hole along the inner circle of the sticker�
3. Through the 3 circles on the sticker, drill 3 pilot holes into the ceiling. Then hammer the sup-
plied three plastic anchors into the holes�
4� Mount the Network Camera to the ceiling and feed the cables�
5. Through the three holes on the side of the camera base, insert the supplied three screws to
corresponding holes and secure them with a screwdriver�
Network deployment
Setup the Network Camera over the Internet
This section explains how to configure the Network Camera to Internet connection �
1. If you have external devices such as sensors and alarms, make connection from general I/O
terminal block�
2� Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.
Use Catagory 5 Cross Cable when Network Camera is directly connected to PC�
3� Connect the power cable from the Network Camera to a power outlet�
1
5
2 3
4
Ceiling Hole Template Sticker
Drill hole
N.C.
N.C.
N.C.
AC24V
AC24V
POWER COLLISION LINK RECEIVE PARTITION 1 2 3 4 5
N.C.
N.C.
N.C.
AC24V
AC24V
N�C�: No Connector
N�C�: No Connector
N�C�: No Connector
AC24V: Power in AC 24V
AC24V: Power in AC 24V
GND: Ground
D I : Digital Input
D O : Digital Output
+12V : Power, 12V DC
GND
DI
DO
+12V
1
2
3