Vivotek FD7141(V) User Manual
Page 12
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
12 - User's Manual
Internet connection via PPPoE (Point-to-Point over Ethernet)
Choose this connection type if you are connected to the Internet via a DSL Line� Please refer to
PPPoE on page 37 for details�
Set up the Network Camera through Power over Ethernet (PoE)
When using a PoE-enabled switch
The Network Camera is PoE-compliant, which allows it to be powered via a single Ethernet
cable�
If your switch/router supports PoE, refer to the following illustration to connect the
Network Camera to a PoE-enabled switch/router via an Ethernet cable.
When using a non-PoE switch
If your switch/router does not support PoE, use a PoE power injector (optional) to connect
between the Network Camera and a non-PoE switch/router.
POWER
COLLISION
LINK
RECEIVE
PARTITION
1
2
3
4
5
N.C.
N.C.
N.C.
AC24V
AC24V
power + data transmission
PoE switch
POWER
COLLISION
LINK
RECEIVE
PARTITION
1
2
3
4
5
N.C.
N.C.
N.C.
AC24V
AC24V
non-PoE switch
PoE power injector
(optional)