Vidikron D-ILA 80 - Manual (Page 21)

21
Basic Operation
1 Turning on the power
1 Insert the power plug to the power outlet. Insert the power plug to the power outlet.
• The main power turns on and the [STAND BY] indicator on the
unit lights up.
2 Press the [POWER] button on the projector (or the [ON] but- Press the [POWER] button on the projector (or the [ON] but-
ton on the remote control unit) for one second or more
• The [POWER] indicator lights up and the projected image
slowly appears.
If setup for this unit is not completed, please refer to “Adjustments and Settings Using Menus” (Pg. 23) upon turning on the power and
perform the required settings accordingly. Once the basic setup is completed, this unit can be used by simply performing the following
operation procedures.
1
2
Notes
• Upon projection, the image may fl icker for a few seconds. This is
not a malfunction.
• When the light source is turned on, the lamp will slowly become
brighter. It will take more than 1 minute for the brightness to
stabilize.
2 Adjusting Zoom
To enlarge the screen size
Turn the zoom ring towards the “Right” side (when looking towards
the screen)
To reduce the screen size
Turn the zoom ring towards the “Left” side (when looking towards
the screen)
3 Adjusting Focus
To focus on nearer points
Turn the focus ring towards the “Right” side (when looking towards
the screen)
To focus on farther points
Turn the focus ring towards the “Left” side (when looking towards
the screen)