Vision Fitness ST250 - Manual (Page 9)

9
1b
1a
1d
1c
1e
1e
2
STEP
• Attach the connecting brace (1a) to
the empty holes on the left floor
support of the base unit (ST200).
Connect with two carriage bolts
(M10x1.5Px60L), two flat (10.5x18x2T)
& spring (SW10.2x18.4x2.5T) washers,
and two nuts (M10x1.5P). Attach the
opposite end of the connecting brace
to the main floor support (1b) of the
leg press. Attach the two bolts already
in (1b) with two flat (10.5x18x2T)
& spring (SW10.2x18.4x2.5T) washers,
and two nuts (M10x1.5P). Tighten all
four nuts with a 17mm wrench.
• Slide the rear vertical support (1c)
over the top of the protruding bolts on
the rear floor support (1d). Loosely
fasten two flat (10.5x18x2T) & spring
(SW10.2x18.4x2.5T) washers and two
nuts (M10x1.5P) to the bolt ends.
Slide this structure and mate with the
bolts attached to the rear of 1b.
Loosely attach two flat (10.5x18x2T) &
spring (SW10.2x18.4x2.5T) washers
and two nuts (M10x1.5P). Attach the
side supports (1e) to the sides of 1b & 1c.
Fasten with four bolts (M10x1.5Px100L),
eight flat (10.5x18x2T) washers,and
four nuts (M10x1.5P) using a 6mm L-
shaped wrench and a 17mm wrench.
Securely tighten all fasteners.
ORANGE BAG