VTech I5808 - Manual (Page 13)

9.Hit "Ok". Now "line or Line In" should show up in the master volume control for
Recording. Please make sure that there is a check mark in the Select box under the "Line
or Line IN
10.Go to Options and Select Properties.
11.There should be an option to adjust Recording or playback volume control. Choose
Playback.
12.There is another section under playback where you pick which volume controls you
want to show on the bar. Make sure there is a check next to "line or Line in". If there is
not, please check it.
13.Hit "Ok". Now "line or Line in " should show up in the master volume control for
Playback. Please make sure that there is a check mark in the MUTE box under the "line
or line in". (it is possible that you may not have a MUTE option, it might be "SELECT".
If you have a choice to SELECT then do not check SELECT under LINE")
14.Now close the Master Volume Control.
Operating Range General
This cordless telephone operates within the maximum power allowed by the Federal
Communications Commission (FCC). Even so, this handset and base can communicate
over only a certain distance --- which can vary with the locations of the base and handset,
the weather, and the construction of your home or office. For best performance, keep the
base antenna fully upright.
If you receive a call while you are out of range, the handset might not ring --- or if it does
ring, the call might not connect when you press [PHONE]. Move closer to the base, then
press [PHONE] to answer the call.
If you move out of range during a phone conversation, you might hear noise or
interference. To improve reception, move closer to the base.
If you move out range without pressing[OFF], your phone will be left "off the hook." To
hang up properly, walk back into range, periodically pressing [OFF].
Handset De-Registration (2455/2461)
1.Disconnect power to the Base (either unplug the DC connector from the bottom of the
Base or unplug the power supply from the outlet). Remove spare battery, if applicable.
2.Hold down the base PAGE key while applying power back to the Base. When the
POWER LED begins to blink, release the PAGE key.
THE USER HAS 15 SECONDS TO BEGIN THE NEXT STEP;OTHERWISE, THE
BASE WILL EXIT PROGRAM MODE.
3.Hold down the PAGE key for 5 seconds. The HANDSET CHARGING LED will be
lit, and after 5 seconds, the LINE IN USE LED will start to flash. Now release the PAGE
key.
4.The HANDSET CHARGING LED will blink 5 times and then go out. Within 5
seconds from when it stops blinking, press and release the PAGE key.
All handsets should now be deregistered.
Conference calls
When call is conferenced, two lines are being bridged through one telephone. The normal
loss that occurs between a station to station call is doubled when using the conference
call feature. The quality of transmission depends on many variables including the amount