VTech I5808 - Manual (Page 2)

CORDLESS Troubleshooting TAGS
250 De-register and register
De-register handset from the E2525, E2600B and E2555
Please take the Handset out of the Base before de-registering. Using the [SOFT] Keys on
the Base, press MENU, then press the Down arrow twice until BASE SETTINGS is
highlighted. Press OK, then press MUTE 3 times and FLASH twice. This will deregister
the unit, please see more info to re-register.
Adding Handsets / Registering Handsets
Your telephone can accommodate up to 8 cordless Handsets. You can add new Handsets
(Model E250, sold separately) at any time, but each must be registered with the Base
before use.
Before using a new Handset, you must register it with the Base. There will be an R in the
upper left hand corner of the display. The Display will read "ENTER BASE ID". Use the
keypad on the Handset to enter Base ID. (To find this number, go to the Base, press
[MENU], scroll down to select DISPLAY BASE ID, then press OK.) Once you have
entered the Base ID number, press OK (middle key under the display). The unit will
display "SEARCHING FOR BASE" and then "FOUND BASE". Your Handset will then
be ready to use.
The Handset provided with your telephone is automatically registered as Handset 1.
Additional Handsets will be assigned numbers in the order the are registered (2, 3, 4, etc.)
up to a maximum of eight.
De-register 250 from the E2520 Base
Take the Handset out of the Base, press [*] [*] [3] [3] [5] [7] [8] [2] on the Base. This
will de-register all of the Handsets at one time. See more information to register them
again.
NOTE: The Base ID code is located on the bottom of the Base.
Adding new Handsets / registering the Handset
Your telephone can accommodate up to 8 cordless Handsets. You can add new Handsets
(Model E250, sold separately) at any time, but each must be registered with the Base
before use.
Before using a new Handset, you must register it with the Base. There will be an R in the
upper left hand corner of the Display. The Display will read "ENTER BASE ID". Use the
keypad on the Handset to enter the Base ID. (To find this number, go to the Base, on the
bottom of the Base will be a white sticker that reads BS ID CODE. The code will start
with a 36. Once you have entered the Base ID number, press OK (middle key under the
display). The unit will display "SEARCHING FOR BASE" and then "FOUND BASE".
Your Handset will then be ready to use.