VTech I5808 - Manual (Page 16)

940101B2-7CPS2A (CRS will not accept a slash.)
The battery save feature will deactivate the ring approximately 60 seconds after being set.
After 60 seconds, the phone will enter "sleep mode". The phone will not ring or display
"incoming call" when the extension phones are ringing. If any button on the phone is
pressed, this will "wake up" the phone. If there is an incoming call within 60 seconds of
a button being pressed, the phone will ring. Once nothing has been pressed for another
60 seconds, the phone will go back into "sleep mode" and will not ring.
ToneLength
Tone length for most cordless telephones is 80-100 milliseconds.
Some services may require longer tones. You need to look for a phone that will continue
to produce a tone signal for as long as a digit is held down. We have many phones with
long tones.
Handset Warmth
It is normal to feel heat near the battery compartment on the cordless handset once the
battery has been fully charged. There is a component in the battery known as a
"separator" which converts excess energy to heat.
Relocate Phone In Home EMI + Sep/Phns
Interference generated by some radio equipment and electrical appliances and machinery
may travel through the air, affecting other types of equipment in close proximity.
Filters cannot help in this situation. Separating the objects may be the only solution.
Split Line w/Triplex + Verify 2 cond cord on line 1
If single line telephone equipment is also experiencing crosstalk, the customer may try
the following remedies:
1.Use shortest line cords possible.
2.Use 2 conductor line cords to connect all single line equipment.
3.Disconnect line 2 wires on any jack where not needed.
Crosstalk
If crosstalk occurs while phones are plugged into the network interface, inside wiring is
NOT the problem. Plug separate phones into the individual interfaces for each line.
Both lines will need to be in use at the same time to get valid test results.
TWO SINGLE LINE JACKS
Verify that 2 conductor line cord is connected to L1/L2 port on telephone. 4 conductor
cord may be used at L2 port.
SINGLE LINE TELEPHONE EQUIPMENT
If single line telephone equipment is also experiencing crosstalk, customer may try the
following remedies:
1.Use shortest line cords possible.
2.Use 2 conductor line cords to connect all single line equipment.
3.Disconnect line 2 wires on any jack where not needed.
TWO-LINE JACKS
·Use triplex adapter and 2 line cords at each affected two-line set.
·Connect cords to L1 and L2 on adapter (not L1+L2) cannot use wall phones with triplex
adapter.
Suggestions for reducing local telephone line recordings: