16 ad v anced opera tion, Installation, Operation – VTech VT 9122 User Manual

Page 16: Belt clip

Advertising
background image

16

AD

V

ANCED OPERA

TION

Your

VT 9122 cordless telephone is equipped with a 2.5mm Headset Jack for use with an

optional accessory Headset for hands-free operation.

If you choose to use the Headset option, you must do the following:

INSTALLATION

* Obtain an optional accessory Head set, which is compatible

with the

VT 9122.

Please contact VTECH Communications Customer Ser-
vice
, in the U.S. toll-free at 1-800-595-9511,in the Canada
call 1-800-267-7377 for dealer information in your local area.
You can also purchase a compatible Headset directly from
VTECH Communications Customer Service.

* Once you have a compatible 2.5mm Headset, locate the

Headset Jack on the Handset of your

VT 9122. Connect

the plug on the Headset to the jack on the cordless Hand-
set. The plug should fit securely. Do not force the connec-
tion. See illustration.

OPERATION

NOTE: Whenever a compatible Headset is connected to the cordless Handset, the micro-
phone on the Handset will be MUTED. This is done to limit the effect of background noise.

* The following operational characteristics apply to VTECH Headsets. the same may also

apply to other (non-VTECH) compatible headsets, but VTECH assumes no responsibility for
their performance.

* The VTECH brand compatible Headset has a monaural design which is reversible, so you

can wear your Headset on either the left or right ear, leaving one ear free for room conversa-
tion.

* The headband can be adjusted to fit the contour of your head.

Using both hands, slide the headband up or down so that it
rests comfortably on your head with the speaker cushion cen-
tered against your ear.

* For maximum sound quality, the flexible microphone should

be positioned at the corner of your mouth, about one inch
from your mouth.

BELT CLIP

*

The

VT 9122 is also equipped with a detachable belt clip.

Align the pins on the inside edge of the belt clip with the
notches on the side of the

VT 9122 handset. The belt clip

should snap securely into place. Do not force the connec-
tion. See Illustration.

OPTIONAL HEADSET INSTALLATION &
OPERATION INSTRUCTIONS

o

Advertising