Installation of battery pack in handset, Getting st ar ted – VTech VT 9122 User Manual
Page 6
6
The Handset of your
VT 9122 is powered by a rechargeable battery pack. It charges automati-
cally whenever the Handset is in the Base Unit. The battery pack needs charging when:
•
The low battery icon is displayed:
•
A beep will be generated every 7 seconds in TALK mode
only. Handset will return to standby if this condition lasts for
3.5 minutes.
To charge the battery pack, place the Handset in the Base Unit. The IN USE/CHARGE indica-
tor will light to show the Handset is seated properly and the battery pack is charging. It is
recommended that the battery pack be charged for at least 16 hours initially. Afterwards, 8
hours of maintenance charging should be sufficient.
To replace the battery pack, follow the steps below:
1. Remove the battery case cover by pressing on the ridged lines and sliding downward.
2. Discard the old battery pack by pulling firmly on the battery cords. Don’t put the old battery
pack in a trash compactor or a fire - it could burst. Please recycle.
3. Snap in the new battery pack. Insert the battery plug into the socket, aligning the two holes
in the plug with the socket pins.
4. Replace the battery case cover by sliding the cover upwards.
5. Place the Handset in the cradle of the Base Unit to allow it to
charge for 16 hours.
CAUTION: To Reduce the Risk of Fire or Injury, Read and
Follow the Instructions
IMPORTANT:
Do not dispose of this battery pack into household garbage. For
information on recycling or proper disposal, consult your local solid
waste collection or disposal organization.
1. Use only VTech rechargeable battery pack, or equivalent.
2. Do not dispose of the battery pack in a fire. The cell may explode.
3. Do not open or mutilate the battery pack. Released electrolyte
is corrosive and may cause damage to the eyes or skin. It may
be toxic if swallowed.
4. Exercise care in handling batteries in order not to short the
battery with conducting materials such as rings, bracelets, and
keys. The battery pack or conductor may overheat and cause
burns.
To purchase replacement battery packs, call VTech at 1-800-595-9511.
INSTALLATION OF BATTERY PACK IN HANDSET
GETTING ST
AR
TED