VTech VT 9122 - Manual (Page 8)

8
The Wall Mount bracket is designed for use on standard Wall Mount plates only.
1. Line up the tabs on the wall mount adaptor with the holes on the bottom of the Base Unit.
Snap the wall mount bracket firmly in place.
2. Plug the AC adaptor into an electrical outlet, and the DC connector to the back of the Base
Unit. If the Handset battery pack has not been charged previously, place the Handset in the
Base Unit cradle, and allow it to charge for 16 hours.
3. Connect the telephone line cord to the jack on the back of the Base Unit, and the other end
to the wall jack.
4. Mount the Base Unit on the wall. Position the Base Unit so the mounting stubs will fit into the
holes on the wall mount bracket. Slide Base Unit down on the mounting stubs until it locks
into place.
5. Flip down the wall mount tab on the Base to secure the Handset when cradled.
GETTING ST
AR
TED
WALL MOUNTING
wallboard
wooden
stud
PAGE