Visioneer 9520 - Manual (Page 21)

14 V ISIONEER O NE T OUCH 9520 P HOTO S CANNER U SER ’ S G UIDE
S
TEP
3: C
ONNECT THE
S
CANNER
Make sure the locking tab is unlocked, then connect the scanner.
To connect your scanner:
1. Remove any tape from the USB cable.
2. Using the steps on the screen as your guide, plug the flat, computer
end of the USB cable into an available USB port on the computer.
3. Plug the other end of the USB cable into the scanner’s USB port.
If the plug does not attach easily, make sure that you are plugging it
in correctly. Do not force the plug into either connection.
You can also connect the scanner to a USB port on the computer’s
keyboard if it has one, or to a USB hub. If you use a USB hub, it
must have its own power supply already plugged into an electrical
outlet.
Note: If you have not installed the software, unplug the USB cable
from the computer and install the software now. When the software
installation is complete, a message tells you to connect the scanner.
USB