Visioneer 9520 - Manual (Page 41)

34 V ISIONEER O NE T OUCH 9520 P HOTO S CANNER U SER ’ S G UIDE
6. Click OK to save your changes and close the OneTouch Properties
window.
7. Press the Scan button on the scanner or click on the Scan button on
the OneTouch Panel.
8. The TWAIN interface will now open.
Note: If you choose to use OneTouch Configure Before Scan for
scanning from the TWAIN interface, the final image will be sent to
the destination application set for that button.
Note: At this time the TWAIN interface is where you will adjust your
scan settings. Please see the following section for adjusting the scan
settings in the Basic and Advanced interfaces. 35mm slide and
negative scanning is only available from the Advanced TWAIN
interface.
This is the Basic
TWAIN Interface
Click either Advanced Interface or Basic Interface to
toggle between the two TWAIN interface options.