Vox VT80+ - Manual (Page 10)

10
REVERB knob
POWER LEVEL control
MOD/DELAY selector
This selects the modulation type, delay type, or other effect type. When you
switch the effect type, the parameter settings of the effect will be initialized.
DEPTH knob
This adjusts the parameter of each effect, such as the depth of the effect.
You can also adjust the modulation speed and other parameters by holding
down the TAP switch and rotating the DEPTH knob.
To turn the modulation/delay effect off, rotate this knob all the way to the left.
TAP switch, LED
This sets the speed of modulation-type effects, or the delay time of delay
effects. The interval between two presses of the switch will be set as the speed
or time.
The LED will blink at intervals of the specified speed or time.
HINT: To set a precise speed or time that matches the tempo of a song,
press the TAP switch several times in rhythm with the song.
If you selected PITCH SHIFT, pressing the TAP switch repeatedly will change
the pitch setting.
If you selected FILTRON, pressing the TAP switch repeatedly will toggle
between UP and DOWN for the envelope. When UP is selected, the TAP LED
will light up.
You can also adjust the speed, pitch, or other parameters by holding down the
TAP switch and rotating the DEPTH knob.
For details, please refer to “Modulation and delay effects” (p. 28).
7. REVERB section
Here you can adjust the settings for reverb effects.
For details on each effect, refer to “Reverb effects” (p. 31).
REVERB knob
Depending on the position of the knob, this selects the reverb
type (ROOM, SPRING, or HALL) or adjusts the mix amount
of the reverb sound.
If you turn the control all the way to the left, the reverb effect will turn off.
8. POWER LEVEL control
This adjusts the output wattage of the power amp.
VT20+:
0W–30W
VT40+: 0W–60W
VT80+: 0W–120W
VT120+: 0W–150W
NOTE: The power level setting is not saved in the
program.