Vox VT80+ User Manual
Page 17
Advertising
17
2.
While holding down the CH1 and CH4 switches, turn on the power. When the
BANK and CHANNEL LEDs start blinking, release the two switches you had
been holding down.
HINT:
If you decide to cancel initialization at this point, press the TUNER
(BYPASS) switch.
3. Press the TAP switch. The BANK and CHANNEL LEDs will change from
blinking to lit, and initialization will begin. In one or two seconds, initialization
will be completed, and the unit will enter Preset mode.
NOTE:
Never turn off the power while initialization is in progress.
Advertising