Vox VT80+ - Manual (Page 16)

16
3. For two seconds or longer, hold down the CHANNEL switch of the channel in
which you want to save the sound. The program will be saved in that channel,
and that bank and channel will be selected.
NOTE: The program that was previously in that location will be overwrit-
ten; i.e., the program that had been in the channel you selected in step 3
will be lost.
NOTE: The setting of the TUNER (BYPASS) switch is not saved in the
program.
NOTE: If you’re creating your sound in Preset mode or Channel Select
mode, the changes you made will be lost if you switch to another pro-
gram or to Manual mode or turn off the power before saving.
Checking the original values saved in a program
The original value indication lets you check the parameter settings that are
saved in a program.
When you turn a knob to change the value of a parameter, the PRESET LED (if
you’re in Preset mode) or the LED of the selected channel (if you’re in Channel
Select mode) will momentarily go dark when the edited value matches the
value that’s stored in the program.
HINT: When you’ve found a program that you like, and are interested in
knowing the actual settings, you can use this original value indication to
find out.
NOTE: The MASTER volume and POWER LEVEL controls are not pro-
grammable, so the original value indication is not available for these
controls. The original value indication will not appear when the tuner
function is turned on in Channel Select mode, nor when the unit is in
Manual mode.
Restoring the factory settings
Here’s how to restore all settings of the VT20+/VT40+/VT80+/VT120+ to their
factory-set state.
NOTE: This operation will erase all programs that had been saved to
channels, and will initialize the factory-set programs.
NOTE: This will also initialize the effect and noise reduction settings that
you made in Manual mode.
1. Turn off the power.