Vivitar Vivicam 2755 - Manual (Page 11)

16
Note: You need not activate the LCD to take
pictures - however, using it while capturing
will shorten the lifespan of your batteries.
Using the LCD Display
Using the built-in Liquid Crystal Display (LCD), you can view pictures in a few seconds
after capturing them. The following section describes how to use the LCD and its
various functions.
Note: To remove all icons from the LCD display, press the Information button
on top of the camera. Pressing it a second time returns all icons to the
screen.
Adjusting LCD Brightness
The LCD display comes with the a brightness feature that allows you to change how
images are displayed on the LCD screen. To turn the brightness of the LCD either
up or down, turn the camera over so that the bottom side is facing up. In the center
of the camera’s bottom side is a radial dial. Turning the dial with your fingernail or a
small coin adjusts the brightness up and down.
Viewing Pictures on the LCD
The Display button turns the LCD display on, allowing you to see each picture as it
is taken.
1 After turning on the Power, press the Record/ Play button to
switch to the Play mode. The LCD display warms up and then displays
the last picture taken. If there are no pictures in the camera, then a message
displays informing you of this.
2 Press the Forward or Backward buttons to scroll through the pictures
stored in memory.