VTech CS6124-2 - Manual (Page 27)

23
Answering system settings
Number of rings
You can choose from two, three, four, five or six rings; or toll saver. With toll saver
selected, the answering system answers after two rings when you have new
messages, and after four rings when you have no new messages. This enables you
to check for new messages and avoid paying unnecessary long distance charges if
you are calling from outside your local area.
Press MENU/
SELECT
when the handset is not in use.
Press CID or to select Answering sys, then press
MENU
/SELECT .
Press CID or to select Ans sys setup, then press
MENU
/SELECT .
Press CID or to select # of rings, then press
MENU
/SELECT.
Press CID or to choose from 6, 5, 4, 3, 2 or Toll save r , then press
MENU
/SELECT to confirm your selection. You hear a confirmation tone.
Remote access code
A two-digit security code is required to access the answering system remotely from
any touch-tone telephone. The preset code is 19. You can set the code from 00 to 99.
Press MENU/ SELECT when the handset is not in use.
Press CID or to select Answering sys, then press
MENU
/SELECT .
Press CID or to select Ans sys setup, then press
MENU
/SELECT .
Press CID or to select Remote code , then press
MENU
/SELECT.
Press the dialing keys ( 0-9) to enter the code or CID or to select from 00
to 99, then press
MENU
/SELECT to confirm your selection. You hear a
confirmation tone.
Message alert tone
This telephone beeps every 10 seconds to alert you of new messages. The tone
stops when all new messages have been reviewed. Press MENU/
SELECT
when the
handset is not in use.
To turn this feature on or off:
Press MENU/
SELECT
when the handset is not in use.
Press CID or to select Answering sys, then press
MENU
/SELECT.
Press CID or to select Ans sys setup, then press
MENU
/SELECT.
Press CID or to select Msg alert tone, then press
MENU
/SELECT.
Press CID or to choose On or Off , then press
MENU
/SELECT to confirm
your selection. You hear a confirmation tone.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
The answering system must be turned on for the message alert tone
to function.
Press any key on the telephone base (except
/FIND HANDSET) to temporarily
silence the message alert tone.
•
•