VTech CS6124-2 - Manual (Page 7)

3
If the handset will not be used for a long period of time, disconnect and remove the
battery to prevent any possible leakage.
Battery installation
Install the battery as shown below.
1
CHARGE light remains
on when charging.
2
3
Plug the battery connector securely
into the socket.
Place the battery with the wires inside
the battery compartment.
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
Place the handset in the telephone
base or charger to charge.
4
If you are on a call in low battery mode, the handset beeps every 50 seconds.
If you place the handset in the telephone base or charger without plugging in the
battery, the screen displays No battery.
•
•
Battery charging
Once you have installed the battery, the screen indicates the battery status. For best
performance, keep the handset in the telephone base or charger when not in use.
The battery is fully charged after 16 hours of continuous charging.
Battery indicators Battery status Action
The screen is blank, or
displays Place in charger
and flashes .
Battery has very little or no
charge. The handset cannot
be used.
Charge without interruption (at
least 30 minutes).
The screen displays Low
battery and flashes.
Battery has enough charge to
be used for a short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X and
-:-- --/--.
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
Getting started