Whirlpool oortable spa - Manual (Page 15)

www.clearcreekspas.com
www.clearcreekspas.com
OPERATION
Operating Instructions
Now that your Quantum Plus spa is in place, you are probably eager to take advantage of its unique designed-in features—
especially the patented Jacuzzi Whirlpool Bath hydromassage performance. Besides being a beautiful addition to your
indoor decor or outdoor landscaping, your Jacuzzi whirlpool spa will provide you with the ultimate in spa pleasure.
Basic Control Set-Up
The control set-up on your Quantum Plus spa is designed to give you fingertip control of the heater, lights, air induction,
Water Rainbow and whirlpool/filter pump and blower systems of your unit from inside or outside your spa. Follow the basic
control set-up described below to familiarize yourself with the several functions of the control panels located on the top of
the spa.
CAUTION
Do not turn on power to the spa unless it is filled with water to the normal water level. (See water line indicatormark
on skimmer frame.) When the power is on, the built-in timer may activate the system even though the SYSTEM is
turned off at the control panel. If the spa’s motor/pump is actuated when there is not sufficient water in the unit,
the circulation pump and heater could be irreparably damaged. In addition to damaging the unit, operating the
spa with insufficient water could cause a fire.
• Using a garden hose, fill the spa with water to the
waterline indicator mark on the skimmer frame. (See
page 20 for information on using Water Rainbow as a
fill spout if desired.)
• At the house service panel, turn on the circuit breaker
or switch that controls the electrical service to your spa.
(Make sure there is no other appliance on that circuit.)
• Open the skirt door giving access to the System Control
Module.
• Your spa is provided with a earth leakage circuit breaker
(ELCB). At initial start-up and at least once a month
thereafter, with power on, push the button located on
the spa System Control Module. The switch should
move to the OFF (O) position. Move the switch to the
ON (1) position to reset. If the interrupter fails to operate
in this manner, there is a ground current flowing or a
device malfunctioning, indicating the possibility of elec-
tric shock. Turn off power and do not use the spa until
the source of the breakdown has been identified and
corrected.
SYSTEM CONTROL MODULE
INTERLOCK
SWITCH CAUTION
This system is GFCI (Ground Fault Circuit Interrupter) pro-tected for your 1. Push TEST button of GFCI.
GFCI JETS
MOT OR/
PUMP
safety. Bypassing the GFCI or tampering with the system in any way may 2. RESET button should pop out. This should cut off power
TEMP.
cause electrical shock, in-jury or death and will void the warranty. GFCI protection does not extend to 230 V AC circuit conversion. If test indi-cates that the GFCI is not functioning, DO NOT USE THE UNIT until the electrical
to the system. CAUTION: if RESET button does not pop out, or if RESET button does pop out and system is still on, DO NOT USE YOUR SPA. problem has been corrected. (See installation instructions.) TEST THE GFCI 3. If the GFCI tests okay, restore power by pushing in the SAFETY
SWITCH
ONCE A MONTH.
TEST PROCEDURE
reset button. The RESET button must be pushed until it locks into place and remains depressed. BLOWER
Unit must be filled to proper water level and correct power supplied. IF THE GFCI FAIL TO RESET PROPERLY, DO NOT USE THE SPA! CONTACT A QUALIFIED ELECTRICIAN.
FLOW SWITCH
TIMER
HEATER
LIGHT #1
FILTER
MOT OR/
PUMP
PLUG-IN
C0NNECTORS
LIGHT #2
Turn dial to correct time and day. Slide tabs toward center for desired operating periods. (One tab = 2 hrs.)
HIGH TEMPERATURE SAFETY SWITCH
High temperatures above the thermostat range will
cause the high temperature safety switch to trip and
the system to turn off. See operating instructions.
When water temperature is less than 100 ° F., reset
by pressing the safety switch reset button located on
the cover of the heater enclosure.
CAUTION: DO NOT BREAK DOOR SEAL;
OPENING DOOR VOIDS W ARRANTY
THIS EQUIPMENT REQUIRES QUALIFIED SERVICE
PERSONNEL FOR PROPER REPAIR. CONTACT YOUR
JACUZZI WHIRLPOOL BATH DEALER FOR SERVICE.
NO USER SER VICABLE PARTS BEHIND THIS DOOR.