Whirlpool oortable spa - Manual (Page 33)

www.clearcreekspas.com
www.clearcreekspas.com
MAINTENANCE
Spa Light
Two lenses, one blue and one red, are provided with
your spa. To change the lens, simply pull the lens out of the
fitting and replace it with the desired colored lens. Two
replacement bulbs (GE Model 912, 12W, 12V) are also
included. Put them in a safe place for future use. When a
bulb burns out, replace it from the back of the light fitting,
pulling out the bulb receptacle.
SPA LIGHT BULB REPLACEMENT
NORMAL
Covering Your Spa
An optional rigid spa cover is available to place on top of
the spa. Use of this cover will help to minimize heat loss and
evaporation, and thus reduce energy costs. The cover is
also an attractive and efficient means of preventing debris
such as leaves and dirt from entering your spa when not in
use. Follow the instructions for use and care provided with
the spa cover.
CAUTION
While the spa cover is rigid, it is not designed to
LOCKING
NUT
LIGHT BULB
LENS
COLORED
FILTER
support any weight. Therefore, as a safety precaution
and to preserve the life of your cover, you must not sit,
stand, or lie on it; nor should you place objects of any
kind on top of it.
Jacuzzi Whirlpool Bath does not guarantee or warrent
this cover.
BULB
RECEPTACLE
Cleaning Your Spa
LIGHT
BEZEL
SHELL
QUANTUM SPA WITH RIGID
INSULATING COVER
Your Quantum Plus spa shell consists of two layers of
plastic materials. Its smooth top surface of acrylic is tough
and durable and contains concentrated color. This is
supported by a substantial thickness of fiberglass-rein-
forced polyester resin. A catalyst causes a chemical reac-
tion during manufacture that bonds these layers perma-
nently into a hard, strong material. With a minimum amount
of care and cleaning, your whirlpool spa will look new for
years.
To clean your spa, simply use a mild non-abrasive liquid
detergent, isopropyl alcohol, or commercially prepared spa
cleaner. Do not use abrasive cleaners. You can protect
and restore the gloss to a dulled surface by applying a
plastic polish specifically designed for use on acrylic fin-
ishes (methylmethacrylate). If an acrylic polish is not
available, an automotive paste wax will do.
Use a spa cleaner for residue buildup at the water level
of the spa surface. This may be applied to the acrylic
surface with a soft cloth and wiped clean. Use sparingly in
small amounts to avoid contaminating the spa water. If
heavily soiled, it may be advisable to lower the water level
2 to 3 inches before cleaning; then refill to normal level.
Repairs to the Acrylic
Minor scratches which do not penetrate the color finish
(acrylic) can be removed with 600-grit wet/dry sandpaper.
Restore the glossy finish with an acrylic polish or a compa-
rable automotive paste wax.
Major scratches or gouges which penetrate the acrylic
surface will require refinishing. Ask your Jacuzzi Whirlpool
Bath dealer for special instructions.