Wayne-Dalton LIGHT COMMERCIAL DOOR 6100 - Manual (Page 12)

12
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
9
Power Drill
7/16” Socket Driver
7/16” Wrench
imPoRTaNT! WhEN CONNECTING A TROLLEY
TYPE GARAGE DOOR OPENER TO ThIS DOOR, A
WAYNE-DALTON OPENER/TROLLEY bRACkET MUST
bE SECURELY ATTAChED TO ThE TOP SECTION
OF ThE DOOR, ALONG WITh ANY U-bARS PRO-
VIDED WITh ThE DOOR. ThE INSTALLATION OF ThE
OPENER MUST bE ACCORDING TO MANUFACTURER’S
INSTRUCTIONS AND FORCE SETTINGS MUST bE
ADjUSTED PROPERLY.
Place the top half of the operator bracket inside the
bottom half and hold flush against the inside of the
top section (as shown). Adjust the top / bottom halves
out against the U-bar and bottom rib; loosely secure
both halves together with (4) 1/4” - 20 x 5/8” car-
riage bolts and nuts.
NoTe: Install the track bolts as far apart as possible
(as shown), when fastening the top / bottom halves
together.
NoTe: For retro fit applications, the adjustable
operator bracket must be aligned with the existing
operator.
Locate the center of the top section and align the
center of both end tabs of the adjustable opera-
tor bracket with the sections center line; align the
adjustable operator bracket vertically.
To attach the adjustable operator bracket:
Attach the operator bracket to the U-bar with (2)
1/4” - 20 x 11/16” self drilling screws and the bot-
tom rib with (2) 1/4” -14 x 5/8” self tapping screws
(as shown).
Now tighten all (4) previously installed carriage bolts
and nuts.
adjustable operator
bracket installation
Align center of both end tabs
with center line of top section
Center line of top
section
Adjustable operator bracket
(Top half)
Adjustable operator
bracket
(Bottom half)
Top section
bottom rib
U-bar
Tighten all (4) carriage
bolts and nuts
(2) 1/4” -14 X 5/8”
Self tapping screws
(4) 1/4” -20 X 5/8”
Carriage bolts and nuts
Typical operator arm
attachment
bottom rib
U-bar
(2) 1/4” -20 X 11/16”
Self drilling screws