Wayne-Dalton LIGHT COMMERCIAL DOOR 6100 - Manual (Page 22)

22
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Operator rail
Trolley operator
OPERATOR MUST bE TESTED AT TIME OF
INSTALLATION AND MONThLY ThEREAFTER AS
DESCRIbED IN YOUR INSTALLATION INSTRUCTIONS
AND OWNER’S MANUAL, TO ENSURE ThAT DOOR
SAFETY FEATURES FUNCTION. FAILURE TO TEST OR
MAkE ANY NECESSARY ADjUSTMENTS OR REPAIRS,
CAN RESULT IN SEVERE OR FATAL INjURY.
1. Install operator rail 1/2” to 1-1/2” (13 - 38 mm)
above high arc of top section of the door.
2. Mount operator to ceiling so that 1” to 1-1/2”
(25 - 38 mm) clearance is maintained between
trolley rail and top section when door is fully
open (trolley rail will slope down towards rear).
3. Attach door arm to operator bracket with clevis
and cotter pin.
4. Attach operator rail to a suitable mounting
surface (2” x 6”) lumber minimum.
5. Attach operator to ceiling using perforated
angles.
imPoRTaNT: ANGLES MUST bE SECURELY ATTAChED
TO SOUND FRAMING MEMbER(S).
waRNiNg
Suitable mounting surface
(2” x 6”) lumber minimum
Clevis pin
Cotter pin
Door arm
Operator
Operator
rail
Perforated angle
Framing members
Perforated
angle
cleaning your garage Door
imPoRTaNT: DO NOT USE A PRESSURE WAShER ON YOUR GARAGE DOOR!
While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been
exposed to dirt-laden atmosphere for a period of time. Slight chalking may also occur as a result of direct exposure to sunlight.
Cleaning the door will generally restore the appearance of the finish. To maintain an aesthetically pleasing finish of the garage door, a periodic washing of the garage door is
recommended.
The following cleaning solution is recommended:
A mild detergent solution consisting of one cup detergent (with less than 0.5% phosphate) dissolved into five gallons of warm water will aid in the removal of most dirt.
NoTe: The use of detergents containing greater than 0.5% phosphate is not recommended for use in general cleaning of garage doors.
NoTe: be sure to clean behind weather stripping on both sides and top of door.
cauTioN: NEVER MIX CLEANSERS OR DETERGENTS WITh bLEACh.
glaSS cleaNiNg iNSTRucTioNS
Clean with a mild detergent solution (same as above) and a soft cloth. After cleaning, rinse thoroughly.
acRylic cleaNiNg iNSTRucTioNS
Clean acrylic glazing with nonabrasive soap or detergent and plenty of water. Use your bare hands to feel and dislodge any caked on particles. A soft, grit-free cloth, sponge
or chamois may be used to wipe the surface. Do not use hard or rough cloths that will scratch the acrylic glazing. Dry glazing with a clean damp chamois.
NoTe: DO NOT USE any window cleaning fluids, scouring compounds, gritty cloths or solvent-based cleaners of any kind.
cleaning