Wayne-Dalton LIGHT COMMERCIAL DOOR 6100 - Manual (Page 21)

21
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Needed:
Tools Needed:
�
�
oPT
io
Nal
iNST
alla
Tio
N
Side lock
Install the side lock on the second section of the door.
Secure the lock to the section with (4) 1/4”-20 x
11/16” self drilling screws. Square the lock assembly
with the door section, and align with the square hole
in the vertical track. The side lock should be spaced
approximately 1/8” from the section edge.
imPoRTaNT: SIDE LOCkS MUST bE REMOVED OR
MADE INOPERATIVE IN ThE UNLOCkED POSITION IF
AN OPERATOR IS INSTALLED ON ThE DOOR.
NoTe: After completing this step, continue with Step
6 on page 10.
(4) 1/4”- 20 X 11/16”
self drilling screws
Power Drill
7/16” Socket Driver
Tape Measure
1/8”
Pull Rope No. 6 screw eye
Pull rope
bottom
bracket
Pull rope
DO NOT INSTALL PULL ROPES ON DOORS WITh
ELECTRIC OPERATORS. ChILDREN MAY bECOME
ENTANGLED IN ThE ROPE CAUSING SEVERE OR FATAL
INjURY.
Pilot drill the location for the No. 6 screw eye.
Screw the No. 6 screw eye into the wood jamb
approximately 48” to 50” (1220 to 1270 mm) from
the floor. Tie the pull rope to the screw eye and to the
bottom bracket as shown.
waRNiNg
Power Drill
Drill bit