Wayne-Dalton LIGHT COMMERCIAL DOOR 6100 - Manual (Page 5)

5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
PR
e-
iNST
alla
Tio
N
PR
e-
iNST
alla
Tio
N
Tools Required
Safety glasses
Flat tip screwdriver
1/4”, 3/8”, 7/16”, 1/2” &
9/16” Wrenches
7/16”, 1/2” & 9/16”
Socket
Phillips head screw-
driver
Ratchet wrench
Power drill
Sawhorse
Gloves
3/8”, 7/16” Socket driver
hammer
Vice grips
Step ladder
Tape measure Level Vice clamps
Pencil
9/32”, 1/2”, 3/16” & 1/8” Drill
bits
Approved winding bars 1/4” Torx bit
Removing an old Door
imPoRTaNT: COUNTERbALANCE SPRING TENSION MUST ALWAYS bE RELEASED bEFORE ANY ATTEMPT IS MADE TO START REMOVING AN EXISTING DOOR.
A POWERFUL SPRING RELEASING ITS ENERGY SUDDENLY CAN CAUSE SEVERE OR FATAL INjURY. TO AVOID INjURY hAVE A TRAINED DOOR SYSTEMS TEChNICIAN, USING
PROPER TOOLS AND INSTRUCTIONS, RELEASE ThE SPRING TENSION.
For detailed information see supplemental instructions “Removing an Existing Door /Preparing the Opening”. These instructions are available at no charge from Wayne-
Dalton Corp., P.O. box 67, Mt. hope, Oh 44660, or at www.wayne-dalton.com.
waRNiNg
P1