White Rodgers 1F95-71 - Manual (Page 25)

25
5. Press SET
CLOCK
once. The display will show the
day of the week as an abbreviation (MO for
Monday, TU for Tuesday, etc.).
6. Press and hold either TIME
FWD or TIME
BACK
until you
reach the current day of the week.
7. Press RUN
PRGM
once. The display will show the
correct time and room temperature alter-
nately.
Program Heating and Cooling
Temperatures
During programming, if you don’t press any
buttons for 5 minutes, the thermostat will enter
the HOLD mode and will maintain a constant
temperature. The display will revert to the alter-
nating time/temperature display. To resume
programming after this happens, press VIEW
PRGM
until you are at the point where you stopped
programming. Then you may continue to enter
your programs normally. If you want to stop
programming at any time, simply press RUN
PRGM
to
resume program operation.
1. Press SYSTEM
SWITCH
until HEAT is displayed.
2. Press VIEW
TEMP
once. The display will continue
to show HEAT. Below HEAT is the letter A,
representing the first programmed heating
temperature (HEAT A). At the right of the
display is the currently programmed HEAT
A setting.