Western Telematic NPS-2HD - Manual (Page 17)

4.1.3. Input Cable Clamp
1. Loosen Screws: Locate the two screws which secure each
input jack to the NPS-2HD back panel. Carefull loosen
each screw to provide sufficient room for the input jack
clamp to be attached.
Note: Make certain to loosen the screws enough to allow
the clamp to be installed, but do not entirely remove the
screws from the NPS back panel.
2. Attach Clamp to Jack: Slip the input clamp into place,
making certain that the screw slots in the base of the clamp
are securely seated over the screws which secure the input
jack to the back panel. Make certain to position the clamp
so the retaining screw (see Figure 4.2) is facing upwards.
Tighten the screws to secure the clamp to the input jack.
3. Connect Plug: Slide the input plug into the cable clamp.
If necessary, loosen the retaining screw to provide room
for the plug. Make certain that the plug is firmly seated in
the jack, and then tighten the retaining screw to secure the
clamp to the cable.
4-3
Installation
Figure 4.2: Input Cable Clamp Installation