Western Telematic NPS-2HD - Manual (Page 42)

7.2. Restoring Saved Parameters
This section describes the procedure for using ProComm to send
saved parameters to the NPS-2HD.
1. Start your communications program and access the NPS
command mode using the System Level Password.
2. Configure your communications program to upload an
ASCII text file.
3. Upload the file with the saved parameters. If necessary,
key in the file name and directory path.
4. When the upload is complete, make certain to terminate
the communications program's upload mode.
Note:
· The current On/Off status of each NPS-2HD plug
will not be saved or restored. However, the
selected default On/Off setting for each plug will
be saved and restored.
· When the configuration file is sent to the NPS-2HD
via telnet, the unit's IP Address, Subnet Mask, and
Gateway Address cannot be altered.
5. Type /SP and press [Enter], the NPS-2HD will display
the Status Screen with passwords revealed. Check the
Status Screen to make certain that saved parameters have
been restored.
7-2
NPS-2HD Heavy Duty Network Power Switch; User's Guide