Western Telematic NPS-2HD - Manual (Page 21)

5. Configuration
5.1. System Mode and User Mode
In order to restrict access to sensitive command functions, the
NPS-2HD features two separate operating modes; System Mode
and User Mode.
The System Mode allows access to all configuration menus,
command functions and status screens. When the System Mode
is active, Boot/On/Off commands can always be directed to
either of the two switched outlets, even if each plug has been
assigned a separate password. The System Mode Status Screen
shows On/Off conditions for both switched outlets, and lists
currently defined system parameters.
The User Mode allows limited access to command functions and
status screens; users are not allowed to access configuration
menus. When the User Mode is active, Boot/On/Off commands
can only be directed to the specific outlet(s) allowed by the User
Password entered at login. If a different User Password is
assigned to each NPS outlet, then a user who accesses the NPS
using the password for Plug 1 is not allowed to boot or switch
Plug 2. On the other hand, if the same User Password is assigned
to both NPS outlets, then that user will be able to direct
commands to both plugs. The User Mode Status Screen only
shows conditions at the outlet(s) owned by the User Password;
system parameters are not displayed.
When properly configured, the NPS will display a password
prompt when the unit is contacted via the Console Port, Modem
Port or Network Port. The password entered at this prompt
determines whether the unit will start-up in System Mode or User
Mode. If the System Password (defined via the General
Parameters menu) is entered, the System Mode will be active. If
the User Password (defined via the Plug Configuration Menus) is
entered, the User Mode will be active.
If the System Password is not defined, the NPS-2HD will not
display the password prompt, and will always start-up in System
Mode. Once the System Password has been defined, individual
users can be granted access by assigning passwords to the NPS's
two switched plugs as described in Section 5.5.
5-1