Weider 831.159830 - Manual (Page 11)

11
82
82
29
28 67
8
90
90
92
26
27
4
7
5
8
9
28
5
78
82
35
15
16
38
29
82
90 92
90
15. Press a 2” Square Inner Cap (67) into the Center
Top Frame (8). Place the Center Top Frame on
the indicated brackets on the Uprights (4, 5).
Note: The tops of the four Weight Guides (26,
27) must be behind the Center Top Frame, as
shown in step 16.
Attach the Center Top Frame (8) to the Butterfly
Top Frame (7) with two 3/8” x 2 3/4” Bolts (82), a
Large Support Plate (29), and two 3/8” Nylon
Locknuts (90). Do not tighten the Nylon
Locknuts yet.
Attach the Center Top Frame (8) to the bracket on
the Butterfly Upright (4) with two 3/8” x 2 3/4”
Bolts (82), a Small Support Plate (28), and two
3/8” Nylon Jamnuts (92). Do not tighten the
Nylon Locknuts yet.
16. Attach the Center Top Frame (8) to the rear hole in
the Press Top Frame (9) with a 3/8” x 2 3/4” Bolt
(82), a Large Support Plate (29), and a 3/8” Nylon
Locknut (90). Do not tighten the Locknut yet.
Locate the parts bag labeled “PULLEY BAG
1.” Remove a 3 1/2” Pulley (35) from the bag.
Slide a 3 1/2” Pulley (35) and a Cable Trap (38)
onto a 3/8” x 4” Bolt (78). Slide the Bolt through the
Large Support Plate (29) and Press Top Frame (9),
and hand tighten a 3/8” Nylon Locknut (90) onto it.
Attach the Center Top Frame (8) to the bracket on
the Press Upright (5) with two 3/8” x 2 3/4” Bolts
(82), a Small Support Plate (28), and two 3/8”
Nylon Jamnuts (92). Do not tighten the Nylon
Locknuts yet.
17. Attach each set of Weight Guides (26, 27) to the
Center Top Frame (8) with two 3/8” x 3 3/4” Bolts
(101), two 3/8” SAE Washers (113), and two 3/8”
Nylon Locknuts (90).
Tighten the 3/8” Nylon Locknuts (90), the
5/16” Nylon Locknuts (86), and the 3/8” Nylon
Jamnut (92) used in steps 2–17.
17
90
90
113
26
27
101
101
8