Weider 831.159830 User Manual
Page 18
18
41. Locate the Weight Plate (48) that is attached
to the bottom of the Bottom Weight (47).
See the inset drawing. Attach the end of the Ab
Cable (74) to the bottom of the Weight Plate (48)
with a 5/16” x 1 3/4” Bolt (96) and a 5/16” Nylon
Locknut (86).
41
48
96
86
74
47
42. Remove a Pro Pulley (110) from the bag
labeled “PULLEY BAG 2.”
Identify the Low Cable (71). It is approximately
142 1/8” long and it has a ball on one end and an
eyelet on the other. Route the eyelet end through
the slot in the cable guide on the Butterfly Base
(1).
Route the Low Cable (71) under the Pro Pulley
(110). Attach the Pro Pulley and a Cable Trap
(38) to the bracket on the Butterfly Base (1) with
a 3/8” x 2” Bolt (93) and a 3/8” Nylon Locknut
(90). Make sure the Cable Trap is positioned to
hold the Cable in the groove of the Pulley.
110
93
71
Cable
Guide
1
90
43. Wrap the Low Cable (71) around a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the indicated hole in the
Butterfly Upright (4) with a 3/8” x 4 3/4” Bolt (102)
and a 3/8” Nylon Jamnut (92). Note: Thread the
Jamnut only two turns onto the Bolt, another
Pulley will be attached to the Bolt in step 45.
Make sure the Cable Trap is positioned to
hold the Cable in the groove of the Pulley.
43
92
38
102
71
35
4
44. Wrap the Low Cable (71) over a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the forth set of holes from
the bottom in the Pulley Plates (32) with a 3/8” x
2” Bolt (93) and a 3/8” Nylon Locknut (90). Make
sure the Cable Trap is positioned to hold the
Cable in the groove of the Pulley.
44
32
38
71
90
93
35
38
42