Weider 831.159830 User Manual
Page 9
9
10. Press a 2” Square Inner Cap (67) into the Press
Top Frame (9).
Attach the Press Top Frame (9) to the indicated
bracket at the top of the Press Upright (5) with
two 5/16” x 2 3/4” Bolts (89), a Medium Support
Plate (109), and two 5/16” Nylon Locknuts (86).
Do not tighten the Nylon Locknuts yet.
11. Identify the Left Weight Guides (27), which have
welded rings near the bottom. Slide two Weight
Bumpers (46) onto the Left Weight Guides. Note:
The wide end of the Weight Bumpers must be
on bottom. Insert the Left Weight Guides into the
indicated holes in the Center Base (2).
Set the other two Weight Bumpers (46) over the
indicated holes in the Center Base (2). Note: The
wide end of the Weight Bumpers must be on
bottom. Insert the Right Weight Guides (26)
through the Weight Bumpers and into the holes in
the Center Base.
10
11
109
9
86
67
5
26
26
2
46
Welded
Rings
27
27
89
12. Attach the indicated Weight Guides (26, 27) to
the Center Base (2) with two 3/8” x 2 3/4” Bolts
(82), four 3/8” Washers (97), and two 3/8” Nylon
Locknuts (90).
2
82
82
97
97
90
90
12