Weider 831.159830 - Manual (Page 12)

12
20. See the inset drawing. Press a Plastic Bushing
(60) onto each welded tube on the Press Frame
(17). Slide the Press Frame into place on the
Press Base (3). Note: This will be a tight fit.
The Plastic Bushings should fit onto each end
of the welded tubes in the Base.
Lubricate the 3/8” x 8” Bolt (106). Attach the
Press Frame (17) to the Press Base (3) with the
Bolt and a 3/8” Nylon Jamnut (92). Do not over-
tighten the Nylon Jamnut; the Press Frame
must pivot easily.
21. Press a 1 3/4” Square Inner Cap (68) into the top
of a Press Arm (18). Press a 1” Round Inner Cap
(66) into the Press Arm.
Attach the Press Arm (18) to the Press Frame
(17) with two 5/16” x 2 1/2” Bolts (87) and two
5/16” Nylon Locknuts (86).
Repeat this step with the other Press Arm (18).
21
68
18
18
17
86
87
66
Arm Assembly
18. Locate and open the parts bag labeled “ARM
ASSEMBLY.”
Press two 2” Square Inner Caps (67) into the
ends of the Leg Lever (13).
Lubricate a 3/8” x 3 1/4” Bolt (104). Attach the
Leg Lever (13) to the Butterfly Leg (11) with the
Bolt and a 3/8” Nylon Jamnut (92). Do not over-
tighten the Nylon Jamnut; the Leg Lever must
be able to pivot easily.
18
67
67
13
92 11
104
Lubricate
19. Lubricate the 3/8” x 3” Bolt (88). Attach the Leg
Press Lever (14) to the Press Base (3) with the
Bolt and a 3/8” Nylon Locknut (90). Do not over-
tighten the Nylon Locknut; the Leg Press
Lever must pivot easily.
19
90
Lubricate
88
3
14
92 Lubricate
17
3
60
17
106
20