Weider WESY93190 - Manual (Page 19)

50. Wrap the Low Cable (86) around a 3 1/2Ó Pulley (82)
in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the welded tube on the Ab
Upright (1) with a 3/8Ó x 3 3/4Ó Bolt (76), a 3/8Ó
Washer (38) and a 3/8Ó Nylon Locknut (42). Orient
the wide tab on the Pulley Covers as shown.
51. Wrap the Low Cable (86) around a 3 1/2Ó Pulley (82)
in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the lower set of holes in the
Pulley Plates (31) with a 3/8Ó x 2 1/4Ó Bolt (99) and a
3/8Ó Nylon Locknut (42). Orient the wide tab on the
Pulley Covers as shown.
52. Wrap the Low Cable (86) around a 3 1/2Ó Pulley (82)
in the direction shown. Attach the Pulley and two
Pulley Covers (94) to the indicated hole in the Ab
Upright (1) with a 3/8Ó x 3 3/4Ó Bolt (76), two 3/8Ó
Washers (38) and a 3/8Ó Nylon Locknut (42). Orient
the wide tab on the Pulley Covers as shown.
19
50
51
52
42
31
42
82
94
99
38
94
86
76
1
94
82
42
38
76
94
1
86
86
38
82
94
Wide Tab
Welded Tube
Wide Tab
Wide
Tab